Dernières nouvelles

Fantastic BD-5J !!!

Between May 15 and August 1, 2012, 3 new BD-5J made ​​their first flight !!!United...


We are sad to report the passing out of one of our founding members, CharlesBezard, on February...

CMC Leopard

M. Ian Chichester-Miles, ancien ingénieur en chef de la division Avions de British Aerospace à  Hatfield (dans le Hertfordshire), a crée la société "Chichester-Miles Consultants" (CMC) avec pour objectif la réalisation d'un jet d'affaires léger de haute performance.

La conception de ce jet de 4 quatre places a débuté en Janvier 1981. Elle était suffisamment avancée pour disposer d'une maquette début de 1982. La conception et la construction du prototype a été confiée à  DesignAbility Ltd Dilton Marsh, dans le Wiltshire. Le travail a débuté en juillet 1982, sous contrat avec CMC.

Le premier vol de cet avion (G-BKRL) a eu lieu le 12 Décembre I988 à  RAE Bedford.

CMC Leopard Mokup, Flight 1982

CMC Leopard one year before first fligth, Press Photo Flight jan 1988

Angus McVitie flew the Chichester-Miles Leopard prototype on its 27min first, Flight january 1989

First Flight

The prototype flew for the first time in decembre 1988 at RAE Bedford, in the hands of Cranfield test pilot Angus McVitie.
CMC has limited the aircraft to 130kt and a maximum altitude of 3,500ft.
The Leopard prototype was tested from speeds as low as 75kt with maximum 41° flap.
Minimum zero-flap speed was less than 90kt.
Undercarriage cycling was proved during this flight.

CMC Leopard, premier prototype avec des moteurs Noel Penny NPT-301

CMC Leopard prototype 001, Press Photo

Avec la courtesie de Malcom Clarke, Cranfield (EGTC), Août 1988. Copyright C Malcolm Clarke 2011



Four-sea light business jet aircraft.


Cantiler mid-wing monoplane. ARA designed wing section and 3D profiles combining laminar flow and super critical wing technology.

Thickness/chord ratio 14% at root, 11% at tip.

Sweepback at quarter-chord 25°.

Two-spar structure, primarily of GFRP, with some carbonfibre reinforcement. Full span electrically actuated trailing-edge flaps of carbonfibre, with deflections of +/- 45° for high drag landing and air-braking/lift dumping. No ailerons or spoilers.

Production aircraft was planned with liquid de-icing and decontamination system in leading-edge.

G-BKRL (cn 001) On display at the 1994 PFA Rally. Cranfield (EGTC) UK, July 3, 1994. Copyright C Malcolm Clarke 2011


Built in three sections : Unpressurised nose section accomodating avionics and nosewheel gear when retract, pressurised cabin section (production aircraft only) and unpressurised rear section providing a baggage bay, with fuel tanks below and equipment bays to rear.

Basic monocoque structure, primarily of GFRP with some carbonfibre reinforcement; fore and aft cabin bulkheads, engine and tailplane axle frames moulded in.

Pressure cabin section divided approximately along aircraft horizontal datum, with upper section formed by electrically actuated upward opening canopy hinged at windscreen leading-edge. Multiple latches around canopy lower-edge. Bonded-in acrylic side windows carry pressurisation tension. Nose opens for access to avionics.